|
Planet-Support-Network Configuration-
- Click on START, then SETTINGS, then CONTROL PANEL.
- Double-click on NETWORK.
- Make sure that you are on the Configuration tab folder and look in the first
text window entitled 'The following network components are installed:' to
insure that you have a Dial-up Adapter and a TCP/IP Protocol
installed. otherwise follow the instructions following to add these in.
- To add in a Dial-up Adapter click ADD (skip if you already have one)
and select ADAPTER from the list of four choices and then ADD
once again.
- On the left, scroll down until you can select MICROSOFT and then
select DIAL-UP ADAPTER from the two choices on the right.
- Click OK, which will load in the dial-up adapter and take you back
to the main Network window.
- Remove every thing except the Adapter you had just added.
- To add in the TCP/IP protocol, select ADD and then select PROTOCOL
from the four choices and then ADD to move on to the selection types.
- For the manufacturer, select Microsoft and then TCP/IP as
the protocol.
- Click OK, which will take you back to the main Network window. (If
it asks to specify the Adapter, do so and select Microsoft and Dial-up Adapter,
then click OK)
- Windows 95 will add TCP/IP. Do not close the Network window at this point
 
|
